Body
Approved bodies only. No homemade bodies.

Custom Works #9012 Eldora
Custom Works #9005 Lumina
Custom Works #9006 T-Bird
Custom Works #9001 Open Comp Camaro
Custom Works #9014 Paducah Late Model
Factory Works #7353 Rocket
Factory Works #7357 Concord
BMS #P103 Shadow
McCallister #207 Tulsa
McCallister #237 Bakersfield
McCallister #250 Vegas Body
McCallister #252 Winchester
Other bodies must be preapproved by management or by DODC.

Bodies may have openings for cylinder head, fuel tank access, glow plug, engine tuning, and exhaust outlets only. The body may not be altered in anyway from its stock configuration i.e.: shortened, lengthened, narrowed etc. Reasonable modification may be permitted to allow for cylinder head cooling only. An under body support may be added to brace each rear quarter panel, but must hold it in stock position, can not be flared out. Molded portion of body must be no longer than 22". Front and rear windows may be removed at trim lines but a flat lexan or similar material deck must be added in cockpit area. Bodies with add on roofs may leave front and rear windows in or out but roofs must be mounted in stock position.

Side Dam
NONE

Rear Spoiler
Maximum rear spoiler is 2.75" from the deck including any molded in portion. A right side spoiler cap is allowed and must follow closely the dimensions in this DODC drawing.

Wheel Base
(determined where outside of tires touch the surface of the track)
Wheelbase 9.5" to 11.5"
Max width 10.00" using foam tires or 10.25"using rubber street tires.

Engine
Any .12 or unmodified RTR .15 sized engine (no .18) Factory built tuned pipes. No carbon fiber pipes. No stinger modifications. Max fuel tank size is 75cc.

NO CARBON FIBER FLYWHEELS. A FLYWHEEL MUST BE FROM A MAJOR REPUTABLE MANUFACTURER THAT IS UNALTERED. WHEN IN DOUBT, SHOW YOUR FLYWHEEL TO THE TECH DIRECTOR.